Oxy Fuel Cutting

Oxy Fuel acidulous (OFC) uses two gases (always oxygen, and usu everyy acetylene) that combine and turn out in a high temperature reaction to rapidly oxidate and burn the metal away. This process is good for cutting starting time carbon brand names. Unfortunately aluminum and most stainless steel cannot be cut with the cutting process. Even small systems ar good for cutting up to two inch deep-chested plate steel. The cut is fairly smooth, but the kerf can be quite large and more than metal can be wasted. The most common fuel used is ethyne, though opposite fuels such as propane, MAPP, propanol, and other gases can be substituted. Acetylene gives the most thermal value when mixed and burned with clean oxygen. This rents shorter preheat times and faster cuts. Some torch systems allow the use of several different gases without major equipment changes other than the cutting tip.

Some Oxy-Acetylene may not support other fuels without major changes to the equipment. Oxy-Acetylene also offers a bonus feature of being sufficient to weld different metals including steel and even aluminum in concert with a special welding tip. Other Oxy-fuels dont reach the inevitable temperature to properly join most metals. Brazing can be through with(p) with alternative fuel torch systems, because the temperature required to braze is much lower.



Soldering can be done with almost all fuel choices. Though limited to cutting mainly steel, it is impelling for use in heating most metals for tempering and deviation/straightening operations. Portability is only limited by size of the gas cylinders selected. bittie cylinders can be bought in a portable pack, and larger ones can be leased. Due to governmental regulations, most companies provide only lease the largest cylinders. Refill of personally owned cylinders when the gases are depleted can be problematic, especially when exchanging or surrogate them at a company other than where the cylinders were originally purchased. storage tank lease can run fifty to eighty dollars per cylinder per year. Many...If you want to get a full essay, order it on our website: Orderessay



If you want to get a full essay, wisit our page: write my essay .